Estudio de la velocidad de corrosión de aceros embebidos en morteros de cemento sustituidos con residuo de catalizador de craqueo catalítico (FC3R)
- Zornoza Gómez, Emilio
- Garcés Terradillos, Pedro
- Payá Bernabeu, Jordi
ISSN: 0465-2746
Año de publicación: 2008
Volumen: 58
Número: 292
Páginas: 27-43
Tipo: Artículo
Otras publicaciones en: Materiales de construcción
Resumen
En este trabajo se ha estudiado el nivel de corrosión de barras de acero embebidas en morteros de cemento Portland con relación agua/material cementante (a/mc) variable (0,3-0,7), en los que parte del cemento (0-20%) se sustituyó por catalizador de craqueo usado (FC3R). Las condiciones de conservación de las probetas elaboradas fueron las siguientes: distintas humedades relativas (40, 80 y 100%) y dos concentraciones de CO2 (5 y 100%). La velocidad de corrosión de los aceros se midió mediante la técnica de resistencia de polarización. Se ha podido determinar que, bajo las distintas condiciones de humedad relativa y ausencia de agresivo, los aceros se mantuvieron correctamente pasivados en los morteros con contenidos de FC3R de hasta el 15%. El nivel de corrosión que presenta el refuerzo embebidos en morteros con sustitución de un 15% de cemento por FC3R y relación a/mc 0,3, al ser sometidos a un proceso de carbonatación acelerada, era muy similar al mostrado por el mortero patrón, sin FC3R.
Referencias bibliográficas
- (1) Baccay, M. A., Otsuki, N., Nishida, T., Maruyama, S.: “Influence of cement type and temperature on the rate of corrosion of steel in concrete exposed to carbonation”. Corrosion 62 (2006) 811-821.
- (2) Pal, S. C., Mukherjee, A. S. R.: Pathak. “Corrosion behavior of reinforcement in slag concrete”. ACI Materials Journal 99 (2002) 521-527.
- (3) Parrot, L. J.: “Some effects of cement and curing upon carbonation and reinforcement corrosion in concrete”. Materials and Structures 29 (1996) 164-173. doi:10.1007/BF02486162
- (4) Parrot. L. J. “A study of carbonation-induced corrosion”. Magazine of Concrete Research 46 (1994) 23-28.
- (5) Batis, G., Pantazopoulou, P., Tsivilis, S., Gadogiannis, E.: “The effect of metakaolin on the corrosion behaviour of cement mortars”. Cement & Concrete Composites 27 (2005) 125-130. doi:10.1016/j.cemconcomp.2004.02.041
- (6) Jiang, L. H., Liu, Z. Q., Ye, Y. Q.: “Durability of concrete incorporating large volumes of low-quality fly ash”. Cem. Concr. Res. 34 (2004) 1467-1469. doi:10.1016/j.cemconres.2003.12.029
- (7) Montemor, M. F., Cunha, M. P., Ferreira, M. G., Simoes, A. M.: “Corrosion behaviour of rebars in fly ash mortar exposed to carbon dioxide and chlorides”. Cement & Concrete Composites 24 (2002) 45-53. doi:10.1016/S0958-9465(01)00025-7
- (8) Payá, J., Monzó, J., Borrachero, M. V., Velázquez, S.: “Evaluation of the pozzolanic activity of fluid catalytic cracking residue (FCC). Thermogravimetric analysis studies on FCC-Portland cement pastes”. Cem. Concr. Res. 33 (2003) 603-609. doi:10.1016/S0008-8846(02)01026-8
- (9) Payá, J., Monzó, J., Borrachero, M. V., Velázquez, S., Bonilla, M.: “Determination of the pozzolanic activity of fluid catalytic cracking residue. Thermogravimetric analysis studies on FC3R-lime pastes”. Cem. Concr. Res. 33 (2003) 1085-1091. doi:10.1016/S0008-8846(03)00014-0
- (10) Payá, J., Monzó, J., Borrachero, M. V.: “Fluid catalytic cracking catalyst residue (FC3R). An excellent mineral by-product for improving early-strength development of cement mixtures”. Cem. Concr. Res. 29 (1999) 1773-1779. doi:10.1016/S0008-8846(99)00164-7
- (11) Payá, J., Monzó, J., Borrachero, M. V., Amahjour, F., Girbés, I., Velázquez, S., Ordónez, L. M.: “Advantages in the use of fly ashes in cements containing pozzolanic combustion residues: silica fume, sewage sludge ash, spent fluidized bed catalyst and rice husk ash”. Journal of Chemical Technology and Biotechnology 77 (2002) 331-335. doi:10.1002/jctb.583
- (12) Su, N., Fang, H.-Y., Chen, Z.-H. Liu, F.-S.: “Reuse of waste catalyst from petrochemical industries for cement substitution”. Cem. Concr. Res. 30 (2000) 1773-1783. doi:10.1016/S0008-8846(00)00401-4
- (13) Alcocel, E. G., Garces, P., Martinez, J. J., Payá, J., Andión, L. G.: “Effect of sewage sludge ash (SSA) on the mechanical performance and corrosion levels of reinforced Portland cement mortars”. Mater. Construcc. 56, nº 282, pp. 31-43 (2006). doi:10.3989/mc.2006.v56.i282.25
- (14) Blanco-Varela, M. T., Martínez-Ramírez, S., Gener, M., et al.: “Modifications induced by adding natural zeolitic pozzolans to cement paste”. Mater. Construcc. 55, nº 280, pp. 27-42 (2005).
- (15) Chen, H.-L., Tseng, Y.-S., Hsu, K.-C.: “Spent FCC catalyst as a pozzolanic material for high-performance mortars”. Cement & Concrete Composites 26 (2004) 657-664. doi:10.1016/S0958-9465(03)00048-9
- (16) Wu, J.-H., Wu, W.-L., Hsu, K.-C.: “The effect of waste oil-cracking catalyst on the compressive strength of cement pastes and mortars”. Cem. Concr. Res. 33 (2003) 245-253. doi:10.1016/S0008-8846(02)01006-2
- (17) Wu, W.-L., Wu, J.-H., Hsu, K.-C., Yen, D.-S.: “Subproducto del fraccionamiento catalítico del petróleo: características, actividad puzolánica y su efecto en las propiedades del mortero”. Cemento Hormigón 850 (2003) 18-25.
- (18) Hsu, K.-C., Tseng, Y.-S., Ku, F.-F., Su, N.: “Oil cracking waste catalyst as an active pozzolanic material for superplasticized mortars”. Cem. Concr. Res. 31 (2001) 1815-1820. doi:10.1016/S0008-8846(01)00693-7
- (19) Pacewska, B., Wilinska, I., Bukowska, M., Nocun-Wczelik, W.: “Effect of waste aluminosilicate material on cement hydration and properties of cement mortars”. Cem. Concr. Res. 32 (2002) 1823-1830. doi:10.1016/S0008-8846(02)00873-6
- (20) Pacewska, B., Bukowska, M., Wilinska, I., Swat, M.: “Modification of the properties of concrete by a new pozzolan. A waste catalyst from the catalytic process in a fluidized bed”. Cem. Concr. Res. 32 (2002) 145-152. doi:10.1016/S0008-8846(01)00646-9
- (21) Stern, M., Geary, A. L.: “A therical analysis of the shape of polarization curves”. Journal of Electrochemical Society 104 (1957) 56. doi:10.1149/1.2428496
- (22) Miranda, J. M., Otero, E., Gonzalez, J. A., et al.: “Behaviour of corroded steel in a Ca(OH)(2)-saturated solution and in cement mortar. Possibility of rehabilitation”. Mater. Construcc. 57, nº 285, pp. 5-16 (2007). doi:10.3989/mc.2007.v57.i285.35
- (23) Andrade, C., González, J. A.: “Quantitavie measurements of corrosion rate of reinforcing steels embedded in concrete using polarization resistance measurements”. Werkst. Korros. 29 (1978) 515. doi:10.1002/maco.19780290804
- (24) Anzola, E., Malave, R., Contreras, A., et al.: “Effect of steel surface conditions on reinforcing steel corrosion in concrete exposed to marine environments”. Mater. Construcc. 55, nº 279, pp. 17-24 (2005).
- (25) Ahmed, S. F. U., Maalej, M., Paramasivam, P., Mihashi, H.: “Assessment of corrosion-induced damage and its effect of the structural behaviour of RC beams containing supplementary cementitious materials”. Progress in Structural Engineering and Materials 8 (2006) 69-77. doi:10.1002/pse.214
- (26) Hou, J., Chung, D. D. L.: “Effect of admixtures in concrete on the corrosion resistance of steel reinforced concrete”. Corrosion Science 42 (2000) 1489-1507. doi:10.1016/S0010-938X(99)00134-1
- (27) Dotto, J. M. R., de Abreu, A. G., Dal Molin, D. C. C., Müller., I. L.: “Influence of silica fume addition on concretes physical properties and on corrosion behaviour of reinforcement bars”. Cement & Concrete Composites 26 (2004) 31-39. doi:10.1016/S0958-9465(02)00120-8
- (28) Dinakar, P., Babu, K. G., Santhanam., M.: “Corrosion behaviour of blended cements in low and medium strength concretes”. Cement & Concrete Composites 29 (2007) 136-145. doi:10.1016/j.cemconcomp.2006.10.005
- (29) Güneyisi, E., Özturan, T., Gesoglu, M.: “A study on reinforcement corrosion and related properties of plain and blended cement concretes under different curing conditions”. Cement & Concrete Composites 27 (2005) 449-461. doi:10.1016/j.cemconcomp.2004.05.006 (30) Yeau, K. Y., Kim, E. K.: “An experimental study on corrosion resistance of concrete with ground granulate blast-furnace slag”. Cem. Concr. Res. 35 (2005) 1391-1399. doi:10.1016/j.cemconres.2004.11.010
- (31) Gu, P., Beaudoin, J. J.: “Obtaining effective half-cell potential measurements in reinforced concrete structures”. Construction Technology Updates No. 18. Ed. National Research Council of Canada, Ottawa, 1998.
- (32) Zornoza, E., Garcés, P., Monzó, J., Borrachero, M. V., Payá, J.: “Compatibility of fluid catalytic cracking catalyst residue (FC3R) with various types of cement”. Advances in Cement Research 19:3 (2007) 117-124. doi:10.1680/adcr.2007.19.3.117
- (33) Arandigoyen, M., Álvarez, J. I.: “Pore structure and carbonation in blended lime-cement pastes”. Mater. Construcc. 56, nº 282, pp. 17-30 (2006). doi:10.3989/mc.2006.v56.i282.24
- (34) Arandigoyen, M., Álvarez, J. I.: “Carbonation process in lime pastes with different water/binder ratio”. Mater. Construcc. 56, nº 281, pp. 5-18 (2006). doi:10.3989/mc.2006.v56.i281.88
- (35) Norma Americana ASTM C876. “Standard test method for half-cell potentials of uncoated reinforcing steel in concrete”.